Airwell KXV Series, Инструкция по эксплуатации

Страница: 112 / 380

Engineering manual
112
2.9.3 Display introduction
F. SIGNAL RECEIVER
G. POWER INDICATOR
This LED will be in red whenever power is on.
Blinks for 3 seconds when heat mode is selected through mode
button.
H. OPERATION INDICATOR
This LED will be in green during operation.
It will blink once when receiving message from remote controller
and keep blinking when there is any fault or protection.
It will blink 3 times when cool mode is selected through mode
button.
I. TIMER INDICATOR
This LED will be in yellow when timing mode in remote
controllers is used.
It will blink after power off when Timers is set to show that timer
counting is lost.
J. FILTER INDICATOR
This LED will be on when air filter requires cleaning.
F. MODE/RESET BUTTON
If filter LED is ON, a short pressing of the mode button will reset filter timer and turn off the filter clean LED.
If filter LED is OFF, mode button is used for forced operation mode in Cooling-Heating-OFF as circle.
If filter LED is OFF, long pressing the button, will entry diagnostic mode. Detail please contact with the technician.
If the air-conditioner can’t be operated by remote controller or LWC, it can be turned on
for cooling or heating, or completely turned off by every short pressing on MODE button (F)
on the display. The MODE button will change the operating status of the unit between
COOLING-HEATING-OFF. Long press the MODE can enters diagnostic mode.
Chart 2-25