Airwell KXV Series, Инструкция по эксплуатации

Страница: 290 / 380

Engineering manual
290
2. “Off” or “ON” button is pressed; X of user address blinks.
3. Adjust X of user address by “TEMP+” and “TEMP-” buttons. Change “X” from 1 to 8.
4. Press “off” button continue, “X” of user address stop blink, “YY” will blink, we can use “TEMP+” button or
“TEMP-“ button change “YY” from 01 to 16.
5. Finally press “On” button, this user address which has been changed will be sent out as PA one by one.
6. Press “Mode” button again, will exit R/W UA function.
Diagnostics ODU/IDU/HRV
1. “Louver” button is used to select the options: current fault diagnostics- history fault diagnostics– exit is scrolled.
2. In current diagnostic mode, diagnostics icon is blink; in history diagnostics mode, the icon is on; exit diagnostic
mode, diagnostics icon is off
3. Up to 80 IDU fault codes can be browsed
4. LWCS reads master or slave ODU history fault code up to 5 and current fault code up to 10.
5. Current fault diagnostics:
1) Press “Temp+” button or “Temp-” button to select group or system: RM-OAT is scrolled, “RM” is
group,
2) Press “On” to confirm the selected object:
i. If ODU is selected:
 The “0x01” will displayed instead of SPT, press “Temp+/Temp-” button will scroll master
ODU-slave 1 ODU-slave 2 ODU-slave 3 ODU, Then “0x01”- “0x02”-“0x03”-“0x04” will be
blinking instead of SPT. press “Off” button to exit to last level.
 Press “On” button to confirm the ODU. LWCS browse fault code by “Temp+” and “Temp-”
button, fault cod will be displayed instead of SPT. Press “Off” button to exit to last level.
ii. If group is selected:
 The min PA of the group will displayed instead of SPT, press “Temp+/Temp-” button will scroll
PA of the group, press “Off” button to exit to last level.
 Press “On” button to confirm the PA, LWCS will send requirement message to selected PA;
selected PA will send all of current fault code (up to 5) to LWCS. LWCS will wait no more than
1 second, even if the fault code number is less than 5, LWCS will save them in its RAM. The
fault codes will be cancelled from its RAM after the PA is not selected. Press “Off” button to exit
to last level.
Diagnostics LWCS itself
1. Press “Louver” for 5 seconds, enter diagnostics LWCS mode, diagnostics icon is on, LED is blinking;
2. Press “Temp+” or “Temp-” button to browse LWCS fault, fault code will be displayed instead of SPT
3. Press “Louver” for 5 seconds again, exit diagnostics LWCS mode, diagnostics icon is off, LED is on;