Airwell KXV Series, Инструкция по эксплуатации

Страница: 252 / 380

Engineering manual
252
Need this step if meet following conditions, or else, skip it.
 If there are two remote controllers in one R/C wiring, then one must be set as master controller, the other must
be set as slave controller.
Note:
If there is only one remote controller in the R/C wiring, it must be master, otherwise, the system can’t work
normally!
Choose one LWC as slave, and change DIP switch 3 to ON position.
ON ON
OFF OFF
 If need set I-feel function
Set DIP switch 2 to ON position.
Note:
Only when exit I-feel function (OFF position), I-feel function is act. For details please find service manual of
LWC.
 Limit for I-feel function:
If set I-feel function by LWC, it will ignore the I-feel command from IR-RC.
If set I-feel function by master LWC, it will ignore the I-feel command from slave LWC and IR-RC.
 Be sure it is in OFF position before reattach the upper part.
 If HRV is connect in the system and controlled by LWC, set P4 to ON position.
 If weekdays is from Sunday to Thursday, set P5 to ON position.
2.2.5 Reattach the upper part of LWC
Note:
Don’t touch the PC board with your hand directly.
First begin fitting from the clips at the bottom.
2
1
Chart 2-4