Airwell KXV Series, Инструкция по эксплуатации

Страница: 103 / 380

Engineering manual
103
2. Please select the position of installation hooks according to the hook holes in the installation board.
 Drill four holes of M12mm, 45-50mm deep at the selected positions on the ceiling. Then embed the expansible
hooks (fittings).
 Face the concave side of the installation hooks towards the expansible hooks. Determine the length
of the installation hooks from the height of ceiling, then cut off the unnecessary part.
 The length could be calculated from Chart 2-10:
Length= H-181+L ( in general, L=100mm and is half of the whole length of the installation hook)
3. Please adjust the hexangular nuts on the four installation hooks evenly, to ensure the balance of the
body.
 If the drainpipe is away, leakage will be caused by the malfunction of the water-level switch.
 Adjust the position to ensure the gaps between the body and the four sides of ceiling are even. The
body’s lower part should sink into the ceiling for 10-12mm (Refer to Chart 2-10).
 Location the air conditioner firmly by wrenching the nuts after having adjusted the body’s position
well.
B.
Install the main body on new built houses and ceilings
1. In the case of new built house, the hook can be embedded in advance (refer to the A.2 mentioned
Above).But it should be strong enough to bear the indoor unit and will not become loose because of concrete shrinking.
2. After installing the body, please fasten the installation paper board onto the air conditioner with bolts (M6
×
12) to
determine in advance the sizes and positions of the hole opening on ceiling.
Please first guarantee the flatness and horizontal of ceiling when installing it.
Refer to the A.1 mentioned above for others.
3. Refer to the A. 3 mentioned above for installation.
4. Remove the installation paper board.
Chart 2-10
Caution:
After completion of installing the body, the four bolts (M6X12) must be fastened
to the air conditioner to ensure the body is grounded well.