Agilent Technologies Agilent 33500 Series, Руководство по эксплуатации и обслуживанию

Страница: 290 / 429

STATus Subsystem Introduction
STATus:PRESet
Clears Questionable Data enable register and Standard Operation enable register.
Parameter Typical Return
(none) (none)
Clear enable register bits:
STAT:PRES
STATus:QUEStionable:CONDition?
Queries the condition register for the Questionable Data Register group .
Parameter Typical Return
(none) +512
Read the condition register (bit 9 is set):
STAT:QUES:COND?
l
The Questionable Data register group provides information about the instrument's quality or integrity.
l
Any or all conditions can be reported to the Questionable Data summary bit through the enable register.
l
Register is read-only; bits not cleared when read.
l
The condition register bits reflect the current condition. If a condition goes away, the corresponding bit is cleared.
l
*RST clears the condition register.
l
The query reads the condition register and returns a decimal value equal to the binary-weighted sum of all bits set
in the register. For example, if bit 12 (decimal value = 4096) is set, the query returns "+4096".
STATus:QUEStionable:ENABle <
enable_value
>
STATus:QUEStionable:ENABle?
Enables bits in the enable register for the Questionable Data Register group . The selected bits are then reported to the
Status Byte.
Parameter Typical Return
Decimal value equal to the sum of the bit decimal values in the register. +512
Enable bit 9 (value 512) in the enable register:
STAT:QUES:ENAB 512
l
Use < enable_value > to specify which bits are reported to the Status Byte. The specified value corresponds to the
binary-weighted sum of the register bits to enable. For example, to enable bit 5 (value 32) and bit 9 (value 512),
the decimal value would be 544.
Agilent 33500 Series Operating and Service Guide 289