Agilent Technologies Agilent 33500 Series, Руководство по эксплуатации и обслуживанию

Страница: 287 / 429

STATus Subsystem Introduction
4 Channel 2 Initiated 16
5 Waiting for Trigger,
Channel 1 32 Instrument is waiting for a trigger. In INIT[1|2]:CONT
OFF, this bit is set after receiving an INIT and while wait-
ing for a trigger. It is cleared after receiving the trigger.
This bit is 0 if the channel is in INIT[1|2]:CONT ON
mode.
6 Waiting for Trigger,
Channel 2 64
7 (Reserved) 128 (Reserved for future use)
8 Configuration
Changed Event 256 This bit is always 0 in the condition register, as it
reflects an event, not a condition.
9 (Reserved) 512 (Reserved for future use)
10 Instrument Locked 1024 If a remote interface (USB or LAN) has a lock (SYS-
Tem:LOCK:REQuest?), this bit will be set. When a
remote interface releases the lock (SYS-
Tem:LOCK:RELease), this bit will be cleared.
11 (Reserved) 2048 (Reserved for future use)
12 (Reserved) 4096 (Reserved for future use)
13 Global Error 8192 This is set if any remote interface has an error in its
error queue, and cleared otherwise.
14-
15
(Reserved) 16,384 -
32,768
(Reserved for future use)
Questionable Data Register Group
The following table describes the Questionable Data Register group.
Bit Bit Name Decimal
Value
Definition
0 Channel 1 Volt-
age Overload 1 Voltage overload on channel 1 output connector. The out-
put has been disabled.
1 Channel 2 Volt-
age Overload 2 Voltage overload on channel 2 output connector. The out-
put has been disabled.
2 (Reserved) 4 (Reserved for future use)
3 (Reserved) 8 (Reserved for future use)
4 (Reserved) 16 (Reserved for future use)
5 Loop Unlocked 32 Function generator has lost phase lock. Frequency accuracy
will be affected.
286 Agilent 33500 Series Operating and Service Guide