98
98
13.
Gather the following engine mounting hardware
as shown below:
◊
1 - DLE 30 Rear carb engine
◊
1 - J’Tec wrap around pitts muffler w/ mounting
bolts
◊
4 - 1/4” Standoffs
(Available From Aeroworks)
◊
4 - 6mm Mounting bolts
◊
10- Large fender washers
14. Use the hardware gathered in the previous step
to install the motor. Ensure there is one extra
fender washer behind the two left standoffs, this
will ensure the engine has the proper amount of
right thrust. When tightening the engine mount-
ing bolts be sure to tighten them evenly and in a
star pattern to prevent crushing the firewall.
15. Distance from front of firewall to front of
engine prop hub is
6 3/4”
.
16. Mark the location where the throttle cable will
exit the firewall as shown below.
17. Use a long drill bit to drill the throttle cable hole.
