32
13. Test fit the tail cone assembly as shown below.
The rudder drive assembly rod should be cen-
tered in the pre cut tail wheel exit hole.
14. Remove the tail cone assembly and mark the tail
wheel bracket where it exits the fuse. This will
allow you to apply glue in the correct area. Make
sure the rod is strait and wont bend or pull on the
rudder.
15. Mix epoxy in mixing cup and use a tapered stick
to apply the epoxy inside the pre-drilled holes in
the trailing edge of the vertical fin Apply epoxy
to each hinge.
16. Apply epoxy to the tail wheel bracket as shown.
Mark Here
