101
101
2. Cut out the area marked in the previous step.
Remember to make the hole smaller than needed
and enlarge to fit, this will ensure a clean instal-
lation.
Beacon Installation
3. Remove the back plate from the light as shown
below.
4. Mark back plate as shown below. Trim off the
excess material.
1. Locate the beacon lens as shown below. Place
the lens on the fuse and mark its location.
Note:
Use the inner mounting circle on the bottom
of the lens to get correct size. The upper flange
will be visible after the lens is glued in place.
Remove
Remove
