39
23. Remove the set screw holding the rudder control
horn in place and use blue loctite to ensure it
will not loosen in flight.
24. Gather the tail cone, tail wheel assembly, and 4
wood screws for mounting of the tail cone as
shown below.
25. Install tail cone to the rear of the fuse using the 4
wood screws supplied in the kit. Remember to
connect the tail light extension at this time.
22. Ensure that the spring keepers are installed on
the clevises and are pushed as far forward as
possible. This will ensure the clevis will not slip
off during flight, zip ties or fuel line may also be
used.
