33
17. Carefully slide the hinges in rudder into each
hinge hole and against the trailing edge of the
fin. Slide the tail wheel bracket into position and
align to mark previously drawn. Wipe away
excess epoxy with alcohol wetted wipes.
18. Ensure there is no gap between fin and rudder.
Allow epoxy to fully cure. Check you have full
rudder deflection before epoxy fully cures.
19. Finished rudder/rudder drive assembly shown
below.
Pull-Pull and Rudder Servo
Installation
.
1. Gather the rudder control linkage parts shown
below.(1) Rudder servo (1) 2 3/4” double output
servo arm (4) servo mounting screws (2) rudder
cables, (2) ball link assemblies, (2) flat washers,
(2) Brass Spacers (2) 4-40 clevises (4) threaded
couplers with lock nut, and (4) brass swaging
tubes.
