100
100
23. Use a 1/4” bit to drill the ignition module
mounting holes.
24. Mount the engine ignition module using nylon
tie and foam rubber as shown.
25. Finished ignition module installation shown be-
low.
26. We recommend installing the carburetor choke
pushrod as shown. Use nylon ties to provide
support and holding friction for the choke push-
rod. Place silicon fuel tubing over the wire
pushrod to prevent damage from vibration and
provide holding friction. Solder a threaded in-
sert on the end of the pushrod to provide a finger
grip.
27. Install muffler to engine at this time. Use blue
loctite on the muffler bolts to ensure it does not
come loose from vibration.
