ZyXEL Communications VES-1000 Series, User Manual, Page: 30 / 227

VES-1000 Series Ethernet Switch
2-4 Hardware Connections
You may also bundle the two Ethernet ports into one logical 200Mbps link.
Default Settings
The factory default settings for the Ethernet ports on the VES-1000 Series switch are:
Speed: Auto
Duplex: Auto
Flow control: Off
Trunking: Disabled
Use a straight through Ethernet cable when connecting the VES-1000 Series switch to an Ethernet switch. Use a
crossover Ethernet cable if you are daisy-chaining the VES-1000 Series switch to another and make sure trunking is
disabled.
2.5 Front Panel LEDs
The following table describes the LED indicators on the front panel of a VES-1000 Series switch.
Table 2-2 LED Descriptions
LED COLOR STATUS DESCRIPTION
On The system is turned on. PWR Green
Off The system is off.
Blinking The system is rebooting and performing self-diagnostic tests.
On The system is on and functioning properly.
SYS Green
Off The power is off or the system is not ready/malfunctioning.
On There is a hardware failure. ALM Red
Off The system is functioning normally.
Blinking The system is transmitting/receiving to/from the VDSL modem.
On The link to the VDSL modem is up.
Port Green
Off The link to the VDSL modem is down.
Blinking The system is transmitting/receiving to/from a 10 Mbps Ethernet
network.
On The link to a 10 Mbps Ethernet network is up.
Green
Off The link to a 10 Mbps Ethernet network is down.
Blinking The system is transmitting/receiving to/from a 100 Mbps Ethernet
network.
On The link to a 100 Mbps Ethernet network is up.
10/100
Mbps
Yellow
Off The link to a 100 Mbps Ethernet network is down.