ZyXEL Communications VES-1000 Series, User Manual, Page: 180 / 227

VES-1000 Series Ethernet Switch
23-2 VDSL-Related Commands
Figure 23-2 CI Commands
23.2 VDSL Commands
The following table is a summary of VDSL-related commands.
Table 23-2 VDSL-related Commands
COMMAND DESCRIPTION
vdsl uprate chan-id (x) This command sets the VDSL upstream rate (0 to 4)
vdsl downrate chan-id (y) This command sets the VDSL downstream rate (0 to 4)
vdsl reset chan-id [lt|nt] This command resets the VDSL chip.
vdsl reconnect chan-id Make VDSL reconnect
vdsl clear chan-id Clear VDSL related counters
vdsl debug chan-id [on|off] This command sets the VDSL debug flag.
vdsl monitor chan-id [on|off] This command sets the VDSL monitor flag.
vdsl status chan-id This command shows the VDSL status counters.
vdsl show chan-id This command shows VDSL settings.
vdsl mode chan-id (mode) This command changes the VDSL mode (0 = 10BaseS, 1 = ANSI, 2
= ETSI).
vdsl active chan-id [on|off] This command actives/deactivates the VDSL driver.
vdsl ver This command shows the VDSL driver version.
vdsl quality chan-id This command shows VDSL quality.
vdsl enet status chan-id This command shows Ethernet status counters.
vdsl enet clear chan-id This command clears Ethernet status counters.
vdsl enet monitor chan-id [on|off] This command sets the VDSL chip Ethernet monitor flag
vdsl enet phy chan-id This command shows the NT Ethernet PHY registers.
“chan-id” (“vdsl01”, “vdsl02”,…”vdsl12”) refers to the channel name for each VDSL channels. “all” is also a
valid channel name that indicate all channels.
All VDSL parameters and flags set using VDSL commands are effective at run-time only. If you
restart the VES, you will lose the configuration changes you made with commands. To save
changes permanently, please use the appropriate SMT menu.
The rest of this chapter shows commonly used VDSL-related CI command examples.
ras> ?
Valid commands are:
sys exit ether vdsl
sw ip
ras>