ZyXEL Communications VES-1000 Series, User Manual, Page: 181 / 227

VES-1000 Series Ethernet Switch
VDSL-Related Commands 23-3
23.2.1 Set VDSL Mode
vdsl mode chan-id (mode)
This command sets the VDSL mode.
After you set the mode is set, you must use “ vdsl reset chan-id ” or “ vdsl recon chan-id ” to force
the VDSL channel to reconnect.
The modes are listed here:
Table 23-3 Set VDSL Mode by CI Command
MODE NUMBER MODE TYPE
0 10Base-S mode
1 ANSI/ETSI Band Plan 998
2 ETSI Band Plan 997
The band plan is different for each mode even though the speed may be the same.
Please refer to the section about VDSL mode for more information on VDSL mode frequency bands and speeds.
23.2.2 Activate / Deactivate the VDSL Driver
vdsl active chan-id [on|off]
This command actives or deactivates the VDSL driver.
After you set the driver, you must use “ vdsl reset chan-id ” or “ vdsl recon chan-id ” to forcibly bring
up the VDSL channel.
23.2.3 Set Upstream/Downstream VDSL Rates
Upstream
vdsl uprate chan-id [uprate]
“uprate” is an integer from 0 to 4 defined in the next table. This command sets the upstream VDSL rate. After you
set the rate, you must use “vdsl reset chan-id” or “vdsl recon chan-id” to reconnect the VDSL channel.
Downstream
vdsl downrate chan-id [downrate]
“downrate” is an integer from 0 to 4 defined in the next table. This command sets the upstream VDSL rate. After
you set the rate, you must use “vdsl reset chan-id” or “vdsl recon chan-id” to make VDSL reconnect.