ZyXEL Communications VES-1000 Series, User Manual, Page: 186 / 227

VES-1000 Series Ethernet Switch
23-8 VDSL-Related Commands
Figure 23-7 VDSL Initialization Messages
These messages are for debugging purposes only. If you are having problems initializing the VDSL connection,
capture this screen and send it to your nearest customer support.
23.2.12 VDSL Monitor Command
vdsl monitor chan-id [on|off]
Type this command to show the VDSL monitor flag status (without “on” or “off”) or turn on/off the VDSL
monitor flag. When this flag is set (on) and the VDSL link is up, VDSL parameters are automatically displayed
every five seconds.
VES-100>State 0 - Initialize
Write default parameters to LT
Goto State 1
State 1 - Wait to connect to default rate
Default rate connected (1113 ms)
VDSL:US 1.56Mbps SNR 34.08dB DS 4.17Mbps SNR 43.08dB
Change Link Watchdog Timer
Goto State 2
State 2 - Check NT EEPROM patch, setup target rate
NT EEPROM exists
NT patch signature 0x55 0x50 0x32, no patch needed
Try to connect target rate (US:0,DS:4)
Write parameters to NT
Write parameters to LT
Goto State 3
State 3 - Wait to connect Target rate
VDSL:US 1.56Mbps SNR 34.08dB DS 16.67Mbps SNR 45.62dB
Target rate connected (1332 ms)
Write default parameters to NT
Write default parameters to LT
Goto State 1
State 1 - Wait to connect to default rate
Default rate connected (1112 ms)
VDSL:US 1.56Mbps SNR 34.08dB DS 4.17Mbps SNR 43.08dB
Change Link Watchdog Timer
Goto State 2
State 2 - Check NT EEPROM patch, setup target rate
Try to connect target rate (US:4,DS:4)
Write parameters to NT
Write parameters to LT
Goto State 3
State 3 - Wait to connect Target rate
VDSL:US 16.67Mbps SNR 37.08dB DS 16.67Mbps SNR 44.65dB
Target rate connected (2314 ms)
Goto State 4
State 4 - Connect State