ZyXEL Communications P-2602HWLNI, User Manual, Page: 123 / 496

Chapter 8 LAN Setup
P-2602HWLNI User’s Guide
123
8.4.1 Configuring Advanced LAN Setup
Use this screen to edit your ZyXEL Device's RIP, multicast, any IP and Windows Networking
settings. Click the
Advanced Setup button in the LAN IP screen. The screen appears as
shown.
Figure 61 Advanced LAN Setup
The following table describes the labels in this screen.
Cancel Click Cancel to begin configuring this screen afresh.
Advanced Setup Click this button to display the Advanced LAN Setup screen and edit more
details of your LAN setup.
Table 29 LAN IP (continued)
LABEL DESCRIPTION
Table 30 Advanced LAN Setup
LABEL DESCRIPTION
RIP & Multicast
Setup
RIP Direction Select the RIP direction from None , Both , In Only and Out Only .
RIP Version Select the RIP version from RIP-1 , RIP-2B and RIP-2M .
Multicast IGMP (Internet Group Multicast Protocol) is a network-layer protocol used to
establish membership in a multicast group. The ZyXEL Device supports both IGMP
version 1 ( IGMP-v1 ) and IGMP-v2 . Select None to disable it.
Any IP Setup Select the Active check box to enable the Any IP feature. This allows a computer
to access the Internet without changing the network settings (such as IP address
and subnet mask) of the computer, even when the IP addresses of the computer
and the ZyXEL Device are not in the same subnet.
When you disable the Any IP feature, only computers with dynamic IP addresses or
static IP addresses in the same subnet as the ZyXEL Device’s LAN IP address can
connect to the ZyXEL Device or access the Internet through the ZyXEL Device.
Windows
Networking
(NetBIOS over
TCP/IP)
NetBIOS (Network Basic Input/Output System) are TCP or UDP packets that
enable a computer to connect to and communicate with a LAN. For some dial-up
services such as PPPoE or PPTP, NetBIOS packets cause unwanted calls.
However it may sometimes be necessary to allow NetBIOS packets to pass
through to the WAN in order to find a computer on the WAN.