Ziton ZP2-AF2-P, Installation Manual

Page: 98 / 176

Chapter 3: Configuration and commissioning
92 ZP2-A Series Installation Manual
DACT configuration
Select DACT configuration to configure settings for an installed DACT expansion
board. Configuration options are shown in the table below.
Table 36: DACT configuration options
Option
Description
General config Configures the DACT status (used or not used) and event reporting
options
Ethernet config Configures Ethernet settings for monitoring network communication
with the central monitoring station (CMS)
Site config Configures the primary CMS, backup CMS, event types to report, and
event reporting mode
CMS config Configures CMS communication and account settings
PSTN config Configures PSTN settings
General configuration
Select General configuration to configure the DACT status (used or not used)
and event reporting settings. Configuration options are shown in the table below.
Table 37: General DACT configuration options
Option
Description Default value
Used Configures the DACT status (used or not used) Not used
FR_ERM [1] Configures the event reporting mode for all configured
central monitoring stations: Fire Routing mode (for alarm
event transmission) if checked or Event Reporting mode if
not checked
Event Reporting
mode
[1] If checked, alarm events are transmitted when the fire routing group is activated and after any
configured activation delay. If the transmission fails, a fire routing acknowledgement fault is
indicated.
To change the configuration:
1. Select Panel setup from the Main menu.
2. Select DACT config, and then select General config.
3. Select and check the check box for the options that you want to enable.
4. Press F4 (Enter), and then press F1 (Back).
5. Press F1 (Save), F3 (Apply), F4 (Discard), or F2 (Exit).
Remember to apply saved settings from the Main menu.