Ziton ZP2-AF2-P, Installation Manual

Page: 69 / 176

Chapter 3: Configuration and commissioning
ZP2-A Series Installation Manual 63
The Reports menu
Use the Reports menu to view, clear, or back up the event log and to display a
variety of system status reports. The reports available to maintenance users are
shown in the table below.
Table 24: Reports available to maintenance users
Report
Description
Event log Displays, clears, or backs up the event log. The event log contains all
the alarm, fault, and condition events recorded by the control panel.
Attention required Displays all devices reporting a fault condition.
Revision Displays your control panel software revision, control panel
configuration revision, and system boards serial number data.
Contact details Displays maintenance or installation contractor contact information
(subject to installer configuration).
Zone status [1] Displays the current status information for zones.
Zone mapping [1] Displays which devices are assigned to each zone in your fire system.
Device status [1] Displays the current status information for control panel devices.
Device information available in real time includes: instant, mean,
maximum, and minimum analog values, alarm level, communication
error rate, and the loop input contamination level.
Panel I/O status Displays the current status information for the control panel inputs and
outputs.
Output Groups status [1] Displays the control panel output groups (sounders, fire routing, fire
protection, or program) that are currently active.
Rules status Displays the control panel rules that are currently active. A rule
consists of one or more states (combined by Boolean operators) that
are configured to trigger specific system actions after a specific
confirmation time. Rules are created using the Configuration Utility.
Firenet status Displays the current status for all control panels in the fire network.
Save/Print reports Saves or prints reports.
PAK List Displays details of all PAKs currently registered to the control panel.
[1] These reports are not available for repeater panels.