4-16
3. Always connect the charger to a GROUNDED
outlet. When using an extension cord, avoid
excessive voltage drops by using a grounded,
3-wire, 12-AWG cord no longer than 7.6 m (25 ft).
(Not Installed in Motorcycle)
1. Remove the power pack from the motorcycle. See
Power Pack Swapping on page 4-8.
2. Connect the charger to the power pack.
The charger can be used on 120 V AC or 240 V
AC current. The voltage does not change the
amount of time that the motorcycle takes to charge.
Note: AVOID connecting the Zero charger and another
device to a single 120 V AC 15A/20A circuit, as it may
become overloaded. Zero chargers draw as much as
10 amps from the 120 V AC circuit when charging.
4.
Charging a fully discharged Zero power pack
takes about 2 hours. When the power pack is
fully charged, disconnect the charger from the
power pack.
5.
Install the power pack into the motorcycle. See
Power Pack Swapping on page 4-8.
