4-1
Starting And Operating
First Time Set-Up
If your motorcycle was direct-shipped you will need to
perform the following:
1.
Remove the motorcycle from its shipping crate.
See Unpacking Your New Zero Motorcycle on
page 4-2.
2.
You must charge the power pack before riding the
motorcycle. See Charging The Power Pack on
page 4-14.
3.
Install the power pack. See Power Pack
Swapping on page 4-8.
4. Identify and inspect the wheels for spoke tension
and/or damage.
5. Check the tire pressure and adjust to proper
specifications. See Tire Inflation on page 5-9.
6. Inspect the hydraulic brake system. Follow the
hydraulic lines from the reservoirs to the calipers
and verify that there are no leaks or damage
to the brake lines. Verify that the brakes function
properly.
7. Make sure the motorcycle key switch is OFF, then
twist the throttle to make sure it’s rotation is
smooth and returns correctly.
8. Inspect bolts and make sure they are tight. See
Bolt Torque Table on page 5-2. Double check the
fork, wheel, and brake bolts.
9. Insert the key in the key switch, engage the rear
brake and turn the key to the ON position. The
charge indicator should read fully charged. It may
take up to 30 seconds before displaying a
full charge.
