4-15
A
Standard Charging
(Installed in Motorcycle)
Does not apply to XU
1.
Ensure the key switch is in the OFF position.
2.
Connect the power pack charger harness to the
power pack connector (A).
3. Always connect the charger to a GROUNDED
outlet. When using an extension cord, avoid
excessive voltage drops by using a grounded,
3-wire, 12-AWG cord no longer than 7.6 m (25 ft).
The charger can be used on 120 V AC or 240 V
AC current. The voltage does not change the
amount of time that the motorcycle takes to charge.
Note: AVOID connecting the Zero charger and another
device to a single 120 V AC 15A/20A circuit, as it may
become overloaded. Zero chargers draw as much as
10 amps from the 120 V AC circuit when charging.
4. Charging a fully discharged power pack takes
about 2 hours. When the power pack is
fully charged, disconnect the charger from the
power pack.
