EDA-Z5008, Z5020 & Z5100 – Technical Manual
ZPControlTechMan_r105
_____________________________________________________________________________________________________
42
11.0 - View Airwaves
View Transmissions in the Airwaves – service and commissioning users
1.Main Menu>>6.View Airwaves
In order to see any transmissions that occur in the airwaves, a menu option is available. This is
particularly useful to see that the receiver of the panel is operational. Only Zerio Plus devices will be
displayed on this screen. (Millennium, Zerio and ‘A series’ devices use a different frequency and
transmission protocol; therefore will not be visible). The screen only displays information for the last
received transmission. If another message is received the previous one is overwritten. The displayed
transmissions can be filtered using the following options.
View All:
Displays every signal received on current RF channel.
View This System:
Only messages from devices that have been previously programmed on to this
system will be listed.
View Single Device: Only messages from a specific, chosen device on the system are listed.
View Type:
Select the device type using the cursor keys. Only messages received for that
type on the system are listed.
12.0 – Battery Stats Reset
When replacing the batteries in a device, it is important to reset the devices’ battery stats. This will
ensure that the new battery level is reported accurately. Failure to reset the battery stats could result
in false low battery faults being shown on the panel. The reset process does not require any use of the
control panel and can be done before or after logging a device on. With the device powered off; while
holding both the reset button and the unit removal button, move the jumper link to the ON position.
Keep holding both buttons down for approximately 10 seconds until the second set of beeps is heard,
then release the buttons.
