Zeiss Axioskop 40, Operating Manual

Page: 65 / 146

Axioskop 40 START-UP
Axioskop 40 FL Attachments and conversions Carl Zeiss
B 40-810 e 12/01 2-35
2.2.12 Installing and removing "Push&Click" modules on the Axioskop 40 FL
The FL P&C reflector modules and optovar and analyzer modules can only be installed on the Axioskop
40 FL, since its stand is equipped with a reflector turret. The following reflector modules can be installed:
FL P&C reflector module # 000000-1046-281
Optovar module 1.25x (for transmitted light only) # 000000-1046-284
Optovar module 1.6x (for transmitted light only) # 000000-1046-283
Optovar module 2.5x (for transmitted light only) # 000000-1046-282
Analyzer module D # 000000-1050-958
Installing a module:
•
Pull the cover cap (2-41/ 1 ) forwards off the
reflector turret.
•
Insert the module (2-41/ 3 ) with the retaining
pins (2-41/ 4 ) from above to the left and right of
the module at an angle into the spring clamps
(2-41/
2 ) on the reflector turret.
•
Then press the module at the top until it snaps
securely into the top spring clamps of the
reflector turret.
Aligning the module when installing it in the
reflector turret:
FL P&C reflector module
the excitation filter faces forward; the emission
filter faces up
Optovar module
the lens faces up; the empty module opening
faces forward
Analyzer module
the analyzer faces up; the empty module
opening faces forward
Fig. 2-41 Changing the FL P&C reflector
module