10-37
IM 701730-01E
Analyzing and Searching Waveforms
10
10.5 Cursor Measurements
• When X-Y Waveforms Are Displayed
4.
Press the
Trace
soft key to select XY1 or XY2.
Proceed to step 6.
Moving the Cursor
6.
Press the
Curs1
/
Curs2
soft key to set the jog shuttle control to
Curs1(Cursor1), Curs2(Cursor2), or both Curs1 and Curs2.
• Select Curs1 to move Curs1.
• Select Curs2 to move Curs2.
• If you select both Curs1 and Curs2, you can move Curs1 and Curs2 vertically
without changing the spacing between the two. The value of the digit being
specified by Curs1 changes.
When X-Y Waveforms Are Not Displayed
When X-Y Waveforms Are Displayed
7.
Turn the
jog shuttle
to move the cursor.
8.
Move
Curs1
/
Curs2
in the same manner according to steps 6 through 7.
Explanation
This section explains the setup procedures for placing cursors on the displayed
waveform (within the display record length, see appendix 1) and displaying various types
of measured values at the cross point of the cursor and waveform. The following four
types of cursors are available.
• Horizontal cursors
• Vertical cursors
• Marker cursors
• Angle cursors
Limitations
Cursor measurements cannot be made on the following waveforms.
• Snapshot waveforms
• Accumulated waveforms (however, measurement is possible on the accumulated
waveform acquired last).
