Xerox DP N24, System Administrator Manual

Page: 123 / 336

Ethernet Menu
Chapter 3: Using the Control Panel
❖
3-59
Default Gateway
Set the four byte Default Gateway
address. The available values are:
xxx.xxx.xxx.xxx
Where xxx = 000 to 255
.
This item only appears if IP Address Res. is
set to
Control Panel
.
For this item (after Step 3), Item Up
moves the cursor to the right through the
displayed Default Gateway address and
Item Down
moves the cursor to the
left. This allows you to change characters
within the string rather than having to
reenter the entire string.
With the cursor displayed under a
character, Value Up
increments the
value of that character and Value
Down
decrements the value.
1. Press Menu Up or Menu
Down until you see:
M e n u s
E t h e r n e t M e n u
2. Press Item Up or Item
Down until you see:
E t h e r n e t M e n u
D e f a u l t G a t e w a y
3. Press Value Up or Value
Down . You will see:
D e f a u l t G a t e w a y =
xxx.xxx.xxx.xxx
4. Press Value Up or Value
Down to change the value of
the character above the cursor. The
value is incremented or
decremented by 1 each time the
key is pressed. Holding down
Value Up
or Value Down
causes continuous scrolling
through the values.
D e f a u l t G a t e w a y =
xxx.xxx.xxx.xxx
5. To change other characters in the
Default Gateway address, press
Item Up
or Item Down
to scroll right or left respectively
through the character string, then
press Value Up
or Value
Down to change the value of
the character above the cursor (as
in Step 4).
D e f a u l t G a t e w a y =
xxx.xxx.xxx.xxx
6. When you have completed setting
theDefault Gateway address, press
Enter
. You will see:
E t h e r n e t M e n u
D e f a u l t G a t e w a y
7. Press On Line . You will see:
R e a d y
Table 3.13 Ethernet Menu functions (continued)
Menu Item and Function Keystrokes Display
Table 3.13 Page 10 of 11