Xerox Document Binder 120, Operator'S Manual

Page: 80 / 138

PREPARING THE BINDER 120 FOR ON-LINE AND OFF-LINE OPERATION
3-12 XEROX DOCUMENT BINDER 120 OPERATOR MANUAL
WARNING: The Interface Module is somewhat heavy. Be careful
when raising the Interface Module.
3. Raise the Interface Module to the triangle (
s
) symbol on the
Angle Registration Label.
NOTE: The Interface Module has two operating positions - the
first position that is angled partially downward and the second
position that is almost all the way up. The Angle Registration
Label denotes each position by a symbol. The triangle (
s
)
symbol represents the first position, which is used for the Xerox
5100, 5800, and 5895. The diamond (
u
) symbol represents the
second position, which is used for the Xerox 5890 and
5680/5892. When you raise the Interface Module to either
position, you will feel the Interface Module lock into place.
4. Squeeze the Alignment Bracket Lever and move the Alignment
Bracket out of its storage position to the triangle (
s
) symbol on
the Alignment Bracket Label.
•
The solid line next to the symbol should be even with the
arrow on the side of the Interface Module.
NOTE: The Alignment Bracket has three positions. The
Alignment Bracket Label denotes each position by a symbol.
The triangle (
s
) symbol represents the position used for the
Xerox 5100, 5800, and 5895. It corresponds to the triangle
symbol on the Angle Registration Label. The diamond (
u
)
symbol represents the position used for the Xerox 5890 and
5680/5892. It corresponds to the diamond symbol on the Angle
Registration Label. The curved arrow symbol represents the
position used when the Binder 120 is in the stand-by or stand-
alone mode and the Interface Module is all the way down. This
position allows the Alignment Bracket to be stored away.
5. Squeeze the Receiving Plate Control Grip and slide it all the way
down.
•
The Receiving Plate will now be fully extended.
0312070A-SBR
0312069A-SBR
0312073A-SBR