Xerox Document Binder 120, Operator'S Manual

Page: 118 / 138

GETTING TO KNOW THE BINDER 120
XEROX DOCUMENT BINDER 120 OPERATOR MANUAL 2-5
Item
#
US Name XL/XCL
Name/Symbol
Description
1 Mimic Display Mimic Display The Mimic Display helps you locate areas that require
your attention. Indicator lights will go on in the
applicable areas of the Mimic Display.
2 Cover Supply Select
Button Cover Supply Select
Button Press this button to select the desired cover source.
The green light to the left of the selection will light.
3 Message Display Message Display The Message Display provides operational information
about the Binder 120.
4 Cover Supply
Contents Display The Cover Supply Contents Display shows the type,
color, and spine width of the covers in Cover Tray 1 and
Cover Tray 2.
5 Language Button Each Binder 120 is enabled for a default language. If
you desire, a Service Representative can enable any
one of 11 other languages as a second language on
your Binder 120. When a second language has been
enabled, pressing the Language button allows you to
switch between the default and second languages. All
messages in the Message Display and Cover Supply
Contents Display will display in the selected language.
6 Energy Saver Button Energy Saver reduces power consumption. Press this
button to enter and exit Energy Saver mode. When
Energy Saver is on, the green light to the right of this
button will light.
NOTE: You can enable Energy Saver only when no
books are in process. If you press Energy Saver while
books are processing, a message will advise you that
the Binder 120 will enter Energy Saver mode when the
binding is done.
7 New Job Button This button enables you to track the number of books
being bound for each job. Press this button to begin
the book count for a new job. Any copy sets already in
the Binder 120 and in the process of being bound will
be identified as part of the current job. At the
completion of the books in the Binder 120, the counter
then will reset to zero. The next copy set that enters
the Binder 120 will become the first book for the new
job.
NOTE: After four minutes of inactivity (i.e., no input to
the Binder 120), the job counter will clear automatically.
It will also clear when you power off the Binder 120.