Xerox Document Binder 120, Operator'S Manual

Page: 63 / 138

MAKING THE BOOKS
XEROX DOCUMENT BINDER 120 OPERATOR MANUAL 4-15
b. For landscape (horizontal) page orientation, insert the copy
set with the cover so that the top page of your copy set
faces the right side of the Binder 120 (as the word
Xerox is
shown in the figure) and the cover spine faces downward
into the Manual Feeder.
NOTE: Follow the orientation labels on the Manual Feeder
area of the Binder 120.
5. Press the Manual Start button on the Control Panel of the
Binder 120.
NOTE: If you are binding more than one book, you can
streamline the process by feeding the sets within 15 seconds of
each other. Doing so eliminates the need to press the
Manual
Start button for each book.
6. Retrieve the bound books from the Output Tray of the Binder
120.
NOTE: The entire binding process for each copy set takes
about two minutes from the time the copy set enters the Binder
120 until it is available as a bound book in the Output Tray of
the Binder 120.
NOTE: When the books exit the Binder 120, you can handle
them and browse through them. You should not, however, allow
them to lie open until the glue in the cover spine has cooled and
reached full strength. The recommended cool-down time
depends on the width of the spine and the number of books.
Refer to the book cool-down table in chapter 8, “Technical data.”
NOTE: Move the Book Guide to the left. This will allow you to
remove the books without causing damage to the covers.
0312042A-SBR