Xerox Document Binder 120, Operator'S Manual

Page: 43 / 138

CUSTOMIZING YOUR BINDER 120
5-2 XEROX DOCUMENT BINDER 120 OPERATOR MANUAL
Descriptions of the Customer Tools features
Below are descriptions of the Customer Tools features. To change
any of these features, follow the instructions in the next section of
this chapter.
Energy Saver This feature automatically reduces the power consumption of the
Binder 120, if the Binder 120 has not been used for a specified time
period. The default time period is one hour. You can adjust this
time period from 0 to 12 hours in 15-minute intervals. If you do not
want to use this feature, set the time period to zero.
You can activate and deactivate Energy Saver mode at any time by
pressing the Energy Saver button on the Control Panel of the Binder
120. As you do so, the green light to the right of the Energy Saver
button goes on and off accordingly.
Spine Width Units Display This feature allows you to specify how you want the Binder 120 to
display cover spine width information in the Message Display and
Cover Supply Contents Display areas of its Control Panel. You can
choose either inches or millimeters. The default for this feature is
“inches” for the United States and Xerox Canada Limited and
“millimeters” for Xerox Limited.
Attention Lamp This feature allows you to enable or disable the Attention Lamp
located at the top of the Control Panel of the Binder 120. This lamp
illuminates to alert you to certain conditions that require your
attention. The default for this feature is “enabled.”
Sound Tone This feature allows you to enable or disable the Sound Tone for the
Binder 120. This tone sounds to alert you to certain conditions that
require your attention. The default for this feature is “enabled.”
Electronic Counter This feature allows you to reset to zero the Electronic Counter that
tracks the number of books bound during a specified period of time.
Typically, you should reset the Electronic Counter monthly for
record-keeping purposes.
Security Code This feature provides access to the Customer Tools features. The
Binder 120 is preset from the manufacturer with a five-button
Security Code. To prevent unauthorized personnel from making
changes to the Customer Tools features, you should change this
default Security Code when you begin using the Binder 120 and
periodically thereafter.
NOTE: Whenever you change the Security Code, be certain to
record the new code somewhere. If you forget the new code, you
must place a service call to have the Security Code reset to the
default value.
Software Version This feature provides you with the software version level of the Main
Board EPROM and UI Board EPROM currently installed on your
machine. This information is read-only. It is especially helpful if you
need to place a call for service. The Customer Service Support
Representative (CSSR) may ask you for this information.