Xerox Document Binder 120, Operator'S Manual

Page: 51 / 138

MAKING THE BOOKS
XEROX DOCUMENT BINDER 120 OPERATOR MANUAL 4-3
Determining the correct spine width
You can use either the Manual Feeder or the Spine Width/Sheet
Capacity table to determine the correct spine width.
Using the Manual Feeder to determine spine width
To use the Manual Feeder for determining the correct spine width,
do the following:
1. Open the Manual Feeder Door.
2. Insert the copy set only (no cover) into the Manual Feeder. The
Binder 120 will measure the thickness of the copy set and the
Message Display will indicate the required spine width.
NOTE: When determining the correct spine width, do not insert
a cover into the Manual Feeder along with the copy set. This
will result in an inaccurate spine width measurement.
3. Remove the copy set from the Manual Feeder.
Using the Spine Width/Sheet Capacity Table to determine spine width
If you are using 20 lb, 24 lb or 80 gsm Xerox paper, you can use the
Spine Width/Sheet Capacity Table located in chapter 8, “Technical
data,” as an alternative to the Manual Feeder for determining the
correct spine width. The table indicates the minimum/maximum
number of sheets allowed for each spine width.
NOTE: If you are adding tabs or inserts made of card stock to your
copy set, the copy set may require a larger cover size than indicated
by the Spine Width/Sheet Capacity Table.
NOTE: If you are using a paper weight that is greater than 24 lbs,
use the Manual Feeder to determine the correct spine width.