Xerox 460, Installation And Troubleshooting Manual, Page: 83 / 210

Xerox Document Centre Network Installation & Troubleshooting Guide Page 11 - 1
Mi
cros
oft W
ind
ow
s
NT 4.X
Ser
ver
M
ic
rosof
t Wind
ows NT
4.X S
erv
er Ne
tw
ork
Microsoft Windows NT 4.X Server
Network (TCP/IP)
Before you Start
NOTE: Your Document Centre has DHCP enabled by default. If you have
configured a DHCP server with TCP/IP information, you can
connect your Document Centre to your network and it will retrieve
its TCP/IP information from the DHCP server when it is turned on.
To enable 100BaseT or a Token Ring interface, refer to Chapter 2
How to Connect to Ethernet or Token Ring Networks to
configure the Speed and Source Routing settings for your
environment.
You can manually assign or use BOOTP or RARP servers to assign
TCP/IP information to your Document Centre. Refer to the section
in this document entitled
Dynamic IP Address Assignment .
If you are using DHCP, perform Steps 1 through 6c but DO NOT
change any values. Then read the note before step 6d and determine
if you wish to change the lpr port number. After choosing,
complete the remainder of the procedure.