Xerox 460, Installation And Troubleshooting Manual, Page: 59 / 210

Xerox Document Centre Network Installation & Troubleshooting Guide Page 7 - 1
UNI
X
Network
s
UNIX Ne
tw
orks
UNIX Networks
Before You Start
To enable 100BaseT or a Token Ring interface, refer to Chapter 2
How to Connect to Ethernet or Token Ring Networks to
configure the Ring Speed and Source Routing settings for your
environment.
NOTE: Your Document Centre now has DHCP, LPR, and NetBIOS over
the IP protocol enabled by default. If your DHCP server will
provide host name, IP address, Gateway address, and Subnet Mask,
the Document Centre TCP/IP information will be configured on
initial boot. This means that if you have configured your DHCP
server with the desired information, you may go right to the section
in this chapter entitled
Go to a Workstation and... .
This procedure assumes you are going to manually set your TCP/IP
information and have recorded the IP Address, Subnet Mask, and
Default Gateway IP address that is to be assigned to your printer. If
it is necessary for your network, you will compute your Broadcast
Address as part of this procedure.
For information on how your printer can connect to a BOOTP
server, or a RARP server to be assigned an IP address dynamically,
refer to the chapter in this document entitled
Dynamic IP Address
Assignment & WINS .
Your Document Centre printer supports printing from a variety of
UNIX platforms. The procedure contained in this document will
enable you to connect your printer in many of these environments.