Xerox 460, Installation And Troubleshooting Manual

Page: 133 / 210

Xerox Document Centre Network Installation & Troubleshooting Guide Page 18 - 3
Offi
ceTr
a
c Net
w
ork
Account
in
g
Office
Trac Ne
tw
ork
A
ccou
n
ti
n
g
Before You Start
NOTE: Your Document Centre now has DHCP, LPR, and NetBIOS over
the IP protocol enabled by default. If your DHCP server will
provide host name, IP address, Gateway address, and Subnet Mask,
the Document Centre TCP/IP information will be configured on
initial boot.
Your printer and your OfficeTrac server must be connected to a
network which has the TCP/IP protocol enabled and all TCP/IP
information such as hostname, Default Gateway and Broadcast
address have been set.
Your Document Centre and OfficeTrac server should be assigned
TCP/IP addresses and the HTTP protocol must have been enabled at
your Document Centre. If necessary, refer to the
Internet Services
Quick Install Card to configure your Document Centre in this
manner.
If Dynamic TCP/IP addressing must be used, be sure to set lease
times long enough to allow for normal maintenenace shutdowns. If
your Document Centre appears to have stopped communicating
with the OfficeTrac server when Dynamic Addressing is in use,
check the TCP/IP settings to be sure they have not changed.
As a quick test to verify all the requirements have been met, start the
Web Browser from your OfficeTrac server and enter the IP address
of the Document Centre to see if you can communicate with it using
the HTTP protocol. If the Browser connects and you can see the
“Home Page” proceed to the next section entitled
Go to the printer
and...