Xerox 460, Installation And Troubleshooting Manual

Page: 35 / 210

Xerox Document Centre Network Installation & Troubleshooting Guide Page 3 - 7
D
ynam
ic
I
P
A
ddr
es
s
A
ss
ignm
ent
& WI
N
S
Dy
n
a
mic IP Address
A
ssign
men
t & WI
N
S
4. Enter the Network Setup menus.
a) Wait for the screen to refresh and press the Connectivity
and Network Setup button.
b) Wait for the screen to refresh and press the Network
Setup button.
c) Press the TCP/IP Options button.
5. Enable TCP/IP printing.
a) Press the TCP/IP Settings button.
b) Press the Protocol and Media button.
c) Press the Enable button. If Physical Media buttons
appear, select either Ethernet or Token Ring . Press
Save .
d) Press the Automatic Addressing button. At the next
screen select RARP and press Save .
6. Press the Exit Tools button.
7. Wait approximately 2 minutes for the printer to receive the
TCP/IP information from the RARP server.
a) Obtain the Configuration Report page from your
printer. Verify the Document Centre printer TCP/IP
information was assigned correctly by the server.
b) Repeat Steps 3a-5a then go to step 8.
NOTE: The Broadcast address will be calculated automatically
8. Set the Host Name (skip steps 8a-8c if your server supplies
this information).
a) Press the Name/Address button.
b) Press the Host Name button.
c) When the soft keypad appears, type the host name
EXACTLY as you want it to appear with proper case.
When finished press the
Save button to record the
changes and exit to the TCP/IP Settings screen.