PAGE 106 OF 126
NIGHT SCAN VERTICAL, VERTICAL COMPLETE, AND VERTICAL HDT
OPERATING INSTRUCTIONS
TP-4836201-H
MAY 2021
WRN 2,06
Pan Stuck
Checked only when
moving out of a limit
position.
The software indicates
the state of the pan
photo sensor has not
changed even though
the motor has been told
to move for more than 1/
2 second
Something is preventing
movement of pan
mechanism, the motor is
defective, or the RCP
board is defective
2,01
Pan Limit Overlap
The software indicates
both pan photo sensors
are blocked
simultaneously
Foreign material in one
of the photos sensors or
faulty photo sensor
2,03
Positioner
Only
TILT pot stuck
No movement detected
in expected direction for
2.0 seconds
Soft stops are not set,
something is preventing
the sense voltage (pot)
movement, the motor is
defective, the sense
voltage is going the
wrong way (miswire), or
the P/T drive board is
defective
2,04
Positioner
Only
PAN pot stuck
2,07
Communication Timeout
The RCP or P-T Drive
board has not sent out
communications
recently
Bad board or connection
in communications link
2,08
Microprocessor error
The RCP board has sent
an invalid message
Indicates a software
problem
2,09 RCP
Only
(Left) Tilt Up wrap
around
The software indicates
the same photo sensor
was made before the
opposite limit photo
sensor was made to
stop rotation. This
indicates wrap around
1. The flag that
interrupts the light may
need to be adjusted to
go deeper into the photo
sensor
2. The limit photo sensor
is defective
2,10 RCP
Only
(Left) Tilt Down wrap
around
2,09
Positioner
Only
Pan Pot Failure
The Positioner software
indicates the pot
feedback voltage is out
of acceptable operating
range
Defective pot, incorrect
wiring, bad connection,
defective P-T board
2,10
Positioner
Only
Tilt Pot Failure
Table 9-2 Error and Warning Codes for RCP (Continued)
Message
Meaning
Root Issue
Potential Cause
Summary of Contents for Night Scan Vertical 4.3-15
Page 2: ......
