PAGE 35 OF 126
NIGHT SCAN VERTICAL, VERTICAL COMPLETE, AND VERTICAL HDT
OPERATING INSTRUCTIONS
TP-4836201-H
MAY 2021
5.4.2
Night Scan Vertical Complete Mounting Instructions
Physically attach the system as follows:
1. Ensure that the control box, mast, and saddle are on a flat surface and in the same plane.
Switches set at the factory are based on a level surface. If the system is not level, these
switches may need adjusted.
2. The areas to which the unit is mounted must be reinforced to withstand mast loads. Be sure
to mount the unit out of reach in order to ensure safety distances and prevent hazardous
zones being reached by upper extremities or the operator or bystanders.
3. Reference Figure 5-3 and Figure 5-4 for mounting hole locations for your system. These
locations will vary based on which system you are using. Drill two 5/16 inch clearance holes
into the vehicle mounting structure where the saddle part of the mast will mount. Drill four 1/4
inch clearance holes into the vehicle mounting structure where the control box part of the
mast will mount. There are four holes for the control box, and two holes for the saddle.
4. Attach the system to the vehicle using 5/16 inch
or M8 bolts and 1/4 inch or M6 bolts
(customer-provided). Torque all hardware as appropriate for its material and size.
It is the responsibility of the customer to properly secure the payload for vehicle travel.
Figure 5-3 Night Scan Vertical Complete Mounting Hole Locations (Control Box Mounted to the
Bottom of the Mast)
Summary of Contents for Night Scan Vertical 4.3-15
Page 2: ......
