PAGE 45 OF 126
NIGHT SCAN VERTICAL, VERTICAL COMPLETE, AND VERTICAL HDT
OPERATING INSTRUCTIONS
TP-4836201-H
MAY 2021
5.4.9.1
Night Scan Vertical
To attach the RCP saddle brackets:
1. Drill six mounting holes into the mounting structure according to Figure 5-11. The brackets
can be used as a template to mark locations.
2. Attach the brackets using 3/8 inch or M8 bolts, lock washers and flat washers (customer-
provided). The installer must select the proper bolt length for the application. The
recommended installation torque for an M8 stainless steel fastener is 15-17 Nm (130-155 in.-
lb.). The recommended installation torque for a 3/8 inch stainless steel fastener is 21-27 Nm
(190-240 in.-lb.). It is recommended to use low strength thread-locking compound.
3. The saddle is adjustable to accommodate all models of the RCP as well as variations in
mounting (Figure 5-12). The saddle must be attached so that it is centered with the RCP and
mast base tube. The height should be adjusted to firmly contact the RCP when the mast is
nested. To adjust the saddle height, loosen the 1/4 inch bolts and slide the bracket upward.
Tighten the four bolts when positioned properly. The nuts have inserts to prevent vibration
loosening. Ensure each nut is tight to the bracket. Ensure the saddle is in contact with the
RCP after tightening.
Figure 5-11 Night Scan Vertical Saddle Mounting Holes
Summary of Contents for Night Scan Vertical 4.3-15
Page 2: ......
