Whirlpool ATE0743RPP, Technical Manual

Page: 12 / 92

2-4
EXTERNAL DRAIN INSTALLATION
(Located On The Exterior
Of The Wall)
1. Peel the backing tape from the gaskets
and mount them on the curved side of one
cover plate and one mounting plate.
2. Place the drain tube through the gasket
and the mounting plate with the flange
toward the wall sleeve.
3. Using 2 - #10 x 1/2
″
sheet metal screws
(provided), attach the drain tube assembly
to one of the 2 drain holes at the rear of the
wall sleeve.
Position the large flange at the bottom of
the sleeve facing toward the sleeve, and
partially tighten the screws. Rotate the
drain tube to a horizontal position to allow
for the wall sleeve to be installed into the
wall. Once the wall sleeve is installed,
position the drain tube to the desired angle.
Before tightening the screws, check to be
sure the tube’s position will allow the wall
sleeve to fit through the wall. Tighten screws.
4. Using 2 - #10 x 1/2
″
sheet metal screws
(provided), attach the cover plate to the
remaining drain hole. Check that the large
flange on the plate is positioned at the
bottom of the sleeve.
NOTE: Check that the 4 overflow slots at
the rear of the wall
5. Discard any unused kit parts.
1. Drain holes
2. Overflow slots
3. Foam gasket
4. Mounting plate 5. #10 x 1/2 in. sheet metal screws
6. 1/2 in. O.D. tube
7.
8.
3
4
3
8
7
5
6
1
2
1
Optional 4 in. (10.2 cm) straight drain tube
Cover plate (no center hole)