General Descriptions
Seite 4 / 180
SAFETY
For the Best Results with
V3000
Series inverter, read this manual and all of the warning sign
attached to the inverter carefully before installing and operating it, and follow the instructions
exactly. Keep this manual handy for your quick reference.
Definitions and Symbols
A safety instruction (message) is given with a hazard alert symbol and a signal word;
WARNING
or
CAUTION
. Each signal word has the following meaning throughout this
manual.
This symbol means hazardous high voltage. It used to call your attention
to items or operations that could be dangerous to your and other persons
operating this equipment.
Read these message and follow these instructions carefully.
This is the "Safety Alert Symbol.." This symbol is used to call your
attention to items or operations that could be dangerous to your or other
persons operating this equipment. Read these messages and follow these
instructions carefully.
WARNING
WARNING
Indicates a potentially hazardous situation which, if not avoided, can result
in serious injury or death.
COUTION
CAUTION
Indicates a potentially hazardous situation which, if not avoided, can result
in minor to moderate injury, or serious damage of product.
The matters described under may, if not avoided, lead to serious
results depending on the situation. Important matters are described
in
CAUTION
( as well as
WARNING
), so be sure to observe them.
NOTE
NOTE
Notes indicate an area or subject of special merit, emphasizing either the
product's capabilities or common errors in operation or maintenance.
HAZARDOUS HIGH VOLTAGE
Motor control equipment and electronic controllers are connected to hazardous line voltages.
When servicing drives and electronic controllers, there might be exposed components with
cases or protrusions at or above line potential. Extreme care should be taken to product against
shock.
Stand on an insulating pad and make it a habit to use only one hand when checking
components. Always work with another person in case an emergency occurs. Disconnect power
before checking controllers or performing maintenance. Be sure equipment is properly
grounded. Wear safety glasses whenever working on an electronic controllers or rotating
electrical equipment.
CAUTION
