Doc. P/N: WSP-009-005
Version: V1.5
Issue Date: October 2013
www.wassp.com
Page 37 of 73
Installation Manual
Ensure that Boat Info is selected and if the connection succeeds but some data is not updating
there are a few possibilities. Check the Device Selection used by HYSWEEP, under normal
conditions it would be expected that these would be:
Figure 31. HYSWEEP Device Selections
If a Roll sensor that is not recognised by HYSWEEP is used it may be possible to configure the
WASSP system to convert the sentence to one recognised by HYSWEEP.
If the Roll sensor is not recognised by WASSP you can still feed this to the HYPACK
®
computer
and use this for roll correction.
WASSP and HYSWEEP can be configured to use the same or different sensors for correction.
As long as the two systems share the same ZDA, the multibeam data will be able to be
synchronised by HYSWEEP along with any other data collected by HYPACK
®
or HYSWEEP.
