LARA | Instructions for use | RIL-1 ENG Rev04 | 28/02/2019 | © 2019 W&H Sterilization Srl
59
Sterilization cycles
2
Check the cycle requirements.
3
Check the icon in the top left corner
of the page to know the drying
mode assigned to the cycle.
4
Tap
to disable the drying mode
(see "Set the drying time" on
page 61).
5
If the door seal is new, hold the
door gently closed until step 7.
6
Tap
and enter your credentials if
required: the door locks. If you have
not set a different start time, the
sterilization starts immediately.
7
Wait the end of the sterilization. Tap
to view the cycle parameters in
real time. See "View the cycle
parameters" on page 62.
8
The sterilization is completed. Tap
to view the cycle summary or
tap
to view the cycle
information. See "View the cycle
parameters" on page 62.
9
Tap OPEN: the door unlocks.
10
If required, enter your credentials
and confirm the release of the load
if needed.
