44
General Configuration
Control panels 20480, 16930, 14480, 01950, 01951, 01952, 01956, 01958, 01960 o 14510, 16950, 20510:
the GSM-BUS communicator 01942 must be given the address of the group of the contact interface generating
the technical alarm to configure
•
Send an SMS message in the form of
<use code>.AT<n>.SET.<group address>
where
<n>
is the index of the technical alarm (on the Communicator) that you want to configure
The value of
<n>
is between 1 and 8
<group address>
must have the form of:
0xABCD
This command does not require an SMS confirmation message.
Example
If the set user code is the default
1234
and the technical alarm is generated by a contact interface corre-
sponding to the address of group
0x0B25
, to configure it on the technical alarm
AT1
of the Communicator,
send the following SMS:
1234.AT1.SET.0x0B25
Note:
If you are using one of the control panels 01950, 01951, 01952, 01956, 01958, 01960 or 14510,
16950, 20510, before configuring the technical alarm on the GSM-BUS Communicator 01942 you need to
“add” the group of the technical alarm on the BUS interface of the GSM-BUS Communicator 01942 To do
this, refer to the instructions manual of the control panel, bearing in mind that the BUS interface of the GSM-
BUS Communicator 01942 behaves as the interface 01848 and that the push-button and the “BUS” LED of
the GSM-BUS Communicator 01942 have the same functions as the interface 01848
13.4.3 Deleting an address
This enables deleting the origin of the technical alarm with an SMS or via EasyTool
This operation disables the warning, by the communicator, of the technical alarm
•
Send an SMS message in the form of
<user code>.AT<n>.SET.0
(zero)
where
<n>
is the index of the technical alarm (on the Communicator) that you want to configure
The value of
<n>
is between 1 and 8
This command does not require an SMS confirmation message.
Example
If the set user code is the default 1234 and you want to delete the configuration of the alarm AT1, send the
following SMS:
1234.AT1.SET.0
