43
General Configuration
13.4.1 Reading an address
This enables reading the origin of the alarm (see instructions manual of the control panel and of the SAI intrusion
detection alarm system control panel), with an SMS or via EasyTool
•
Send an SMS message in the form of
<user code>.AT<n>.?SET
where
<n>
is the index of the technical alarm whose configuration address you want to read
The value of
<n>
is between 1 and 8
The communicator will send an SMS with the data related to the association:
GSM-BUS 1/1
AT<n>:
<address>
Example
If the set user code is the default 1234 and the technical alarm AT1 is generated by a contact interface
(group address 0x0015) of the SAI intrusion detection alarm system control panel, upon sending the following
SMS message:
1234.AT1.?SET
The communicator will send the following SMS:
GSM-BUS 1/1
AT1:
0x0015
Note: The digits representing the address are given in hexadecimal form.
13.4.2 Setting an address
This enables setting the origin of the technical alarm (see instructions manual of the control panel and of the SAI
intrusion detection alarm system control panel), with an SMS or via EasyTool
