Vidikron PlasmaView VP-42, Owner'S Manual

Page: 7 / 117

6
Important Information
NOTE:
When you connect a computer to this monitor, use an RGB cable
including the ferrite core on both ends of the cable. And regarding
DVI and power cable, attach the supplied ferrite cores. If you do not
do this, the monitor will not conform to mandatory FCC standards.
Attaching the ferrite cores: Set the ferrite cores on both ends of
the DVI cable (not supplied), and both ends of the power cable
(supplied). Close the lid tightly until the clamps click. Use the
band to fasten the ferrite core (supplied) to the DVI cable.
» To avoid damage and prolong operating life:
1. Use only with 120V 50/60Hz AC power supply. Continued
operation at line voltages greater than 120 Volts AC will shorten
the life of the unit, and might even cause a fire hazard.
2. Handle the unit carefully when installing it and do not drop.
3. Set the unit away from heat, excessive dust, and direct sunlight.
4. Protect the inside of the unit from liquids and small metal
objects. In case of accident, unplug the power cord and have it
serviced by an authorized Service Center.
5. Do not hit or scratch the panel surface as this causes flaws on
the surface of the screen.
6. For correct installation and mounting it is strongly recommended
to use a trained, authorized dealer.
7. As is the case with any phosphor-based display (like a CRT
monitor, for example) light output will gradually decrease over
the life of a Plasma Display Panel.
8. To avoid sulfurization it is strongly recommended not to place
the unit in a dressing room in a public bath or hot spring bath.
DVI cable (not supplied)
core (small) core (small)
Connector
band
band
Power cable (supplied)
core (large)
core (large)