INS (Insert) Event was
created instead of a
Scene Event.
The Record VCR (R) was selected when IN or
OUT was pressed. Delete the Insert Event, then
select a source VCR and press [IN] or [OUT].
LCD Display is hard to
read.
Adjust the LCD contrast. To do this press
[SETUP] to display Setup Menu 1; with the
cursor on LCD, press [OK] to display the LCD
Contrast screen. Press [CHG] to access change
mode, then turn the jog (shuttle must be in
pause) until the desired contrast setting is
reached. Press [OK] to save the setting and
return to Setup Menu 1. Press [SETUP] to
return to the EDL.
Missed scene.
Scene may be too close to the start of the tape.
Scenes that start earlier than 45 seconds or one
minute from the start of the tape should not be
used.
If an A/B Roll is specified, the "A" or "B" scene
may be shorter than the duration of the
transition. Either lengthen the scene or increase
the speed (decrease the duration) of the
transition.
If neither of the above apply, increase the PLY
(play) Advanced Parameter by five (5) seconds,
but be sure that the REW (rewind) parameter
value is equal to or greater than PLY and that
both are less than the FFD (fast forward)
parameter.
If external VITC or LTC is not being used,
instead of increasing the PLY parameter you
can decrease the STABLE parameter from 45 to
15.
MX-1 Color Is Not
Updated.
If a Source (SRC) Event with an MX-1 Color is
the first event in an auto-record, either the
Record VCR must be put in Record Pause
manually before the auto-record is started, or
the MX-1 must be set up manually with the
correct color.
