DOC: 03-925996-01
DESC:
Assy, 1177 Injector, W/Pressure Sense
PAGE:
REV
7 of 9
1
PREPARED BY: Sax Makthepharack REVISED BY:
CONTROL: INDUSTRIAL ENGINEERING
REV. DATE:
SHOWN
-
12 - 24 - 99
Steve Swihart
1.2.14 Install the Insulation Cover (03-925967-01), over the injector and
snap in place. If the injector cover doesn’t snap in place, the legs
of the injector need to be bent outward. Bend either leg, or both
legs, outward as shown.
1.2.15 Make sure there is a gap between the insulation and the top
of the block, using an allen wrench or small screwdriver top
push the insulation down.
PULL AND BEND LEGS OUTWARD
TO MAKE COVER SNAP IN PLACE
INSULATION SHOULD COVER
STICK UP ABOVE COVER
USE ALLEN WRENCH OR
SMALL SCREWDRIVER TO
PUSH INSULATION DOWN
