DOC: 03-925996-01
DESC:
Assy, 1177 Injector, W/Pressure Sense
PAGE:
REV
2 of 9
1
PREPARED BY: Sax Makthepharack REVISED BY:
CONTROL: INDUSTRIAL ENGINEERING
REV. DATE:
SHOWN
-
12 - 24 - 99
Steve Swihart
INJECTOR SWITCH ASSEMBLY INSTALLATION
HEATER INSTALLATION/EXPLODED VIEW
NOTES:
1. INSTALL TIE WRAP ABOUT WIRES FROM BOTH THE HEATER AND THE
03-925971-01
ACTUATOR KNOB, 1177
03-925981-01
ACTUATOR SPACER, 1177
03-925975-01
ASSY, INJECTOR NUT, 1177
03-925989-01
SEPTUM, HI-TEMP, 9MM THERMOGREEN
13-312004-00, 2 PLCS
NUT, 4-40 KEPS, 18-8
12-312004-14, 2 PLCS
SCREW, 4-40 X 7/8 SOC CAP, 18-8
03-925374-01
PLATINUM PROBE
22-119727-00
4” CABLE TIE, .10W
PANDUIT PLT1M76
03-925978-01, 3 PLCS
ΙΝΣΥΛΑΤΙΟΝ,
1177
ΙΝϑΕΧΤΟΡ
03-925964-02
INJECTOR HEATER BLOCK
03-925964-01
INJECTOR HEATER BLOCK
INJECTOR SWITCH
ASSEMBLY (REF.)
03-925987-01
HEATER, CARTRIDGE, 100W, 120V
AB
OU
T 1
”
1
END CAP (REF.)
ABOUT 1/4” FROM
TOP OFF BRACKET
2
PLATINUM PROBE, ABOUT 1” FROM THE MIDDLE OF THE INJECTOR.
2. AFTER THE INSULATION COVER IS INSTALLED, USE A SCREWDRIVER OR
ALLEN WRENCH TO PUSH THE INSULATION DOWN SO THAT IT DOESN’T
COME UP PAST THE TOP OF THE HEATER BLOCKS. SEE STEP 1.2.15.
03-925967-01
INJECTOR INSULATION COVER
(HAS HOLES IN TOP/BOTTOM)
15-999802-00
COUP., Q.D. TERM, 22-18
03-925998-01
ASSY, INJECTOR SWITCH
3. BEND TUBING AS DESCRIBED IN STEPS 1.2.16 THRU 1.2.18.
SEE STEPS 1.2.16 THRU 1.2.18
TO BEND TUBING TO REQUIRED
CONFIGURATION
HAVE TWO TEES
HAVE ONE TEE
SEE FIGURE 1:
FOR 1177 INJECTOR WITH
W/PRESSURE SENSE
SEE FIGURE 2:
FOR 1177 INJECTOR
NO PRESSURE SENSE
