DOC: 03-925996-01
DESC:
Assy, 1177 Injector, W/Pressure Sense
PAGE:
REV
8 of 9
1
PREPARED BY: Sax Makthepharack REVISED BY:
CONTROL: INDUSTRIAL ENGINEERING
REV. DATE:
SHOWN
-
12 - 24 - 99
Steve Swihart
1.2.16 Bend the lowest tubes coming out of the slot in the injector
bracket down, then out, so that they are parallel to the base
of the injector and as close to it as possible.
1.2.17 Bend the tubing from the purge head tubes down to the base
of the injector, then out, watching purge head to be sure it
doesn’t move and thus damage the glass insert. The lines
should not interfere with the inject switch and should be as
close to the base of the injector as possible.
BEND THESE LINES SO THEY ARE AS
NEAR THE DOTTED LINE AS POSSIBLE
BEND TUBING CLOSE
TO INJECTOR BASE
TUBING MUST NOT INTERFERE WITH SWITCH
2 LINES FROM PURGE HEAD
