9. Reinstall the four screws and tighten them evenly until they stop.
Reinstalling the Source
1. With the trap oven screws on the bottom, place the ceramic spacers in their
countersunk holes.
2. Align the magnet structure with the three ceramic spacers, insert the screws
and tighten.
3. Place the source into the end cap and align the two screws. When the
internal source is properly installed, the lens sits flat in the end cap and the
source plate is flat against the magnet structure. Check for proper positioning
then tighten the screws.
69 of 127
Summary of Contents for 4000 GC
